Shale shaker in preparation for operation, the technical personnel to carry out a basic inspection, especially the new shaker, but also to carry out a detailed inspection, inspection work completed, all aspects of the operation standard, you can start the shale shaker.
The matters needing attention in the use inspection of vibrating screen are:
- Check whether the attached safety splint should be removed before starting;
- Check whether the screen surface on the screen is pressed;
- Check whether all locking parts are firm;
- Check the connection between vibration motor and screen body;
- Check the connection between rubber pad, screen body and frame;
- Check the vibration motor;
- Check the power supply voltage of the vibrating motor;
- Check the interlock control device of the vibration motor;
- The staff shall remove the end caps at both ends of the vibrating motor used on the shaker, and then check whether the phase Angle corresponding to the fan block is consistent. The staff shall then tighten the fastening screws of the fan block;
- The installation angles of the two motors shall be consistent;
- Check the feeding device;
- Tighten the gate;
- No-load test of the shale shaker;
- During the test, there shall be no collision or abnormal sound between the screen body and the frame;
- Check the amplitude, the screen body for reciprocating linear movement should not have distortion and other abnormal phenomena;
- After 10-15 minutes of operation, tighten the bolts for the driving mechanism with a wrench.